Straight answers and careful work on metal roof installation in Tulsa, OK. Metal roofing is our specialty, but we do the whole roof.
We have been setting metal panels on houses, churches, barns and additions for over twenty years, and the crews serving Tulsa install them the same way we always have. Straight lines, correct fastener spacing, and closures at the ridge so wind driven rain has nowhere to go.
Roofing Brothers has been doing metal roof installation since 2002, first around Morganton, North Carolina and now for Tulsa homeowners through our network of local crews. The standard has not moved: measure it right, fasten it right, and never cut a corner where water can find it.
Before any metal roof installation starts in Tulsa you will know the price, the material and the schedule. Estimates are always free, and nobody is going to push you to decide while somebody is still standing in your driveway.
How a job actually runs, from the first phone call to the last magnet pass over the driveway.
Panel type comes first — standing seam or exposed fastener — then color, then trim. We walk you through the trade offs on each one.
If the shingles are coming off, they come off, and every board underneath gets checked before anything new goes down.
We keep panels straight to a line rather than to the eye, because a metal roof shows every bit of drift the moment the sun hits it.
Every penetration gets a proper boot or flashing instead of a bead of sealant and a hope.
Questions homeowners ask us about this kind of work.
Around twenty standard colors. Green, burgundy, bronze, black, gray, tan and barn red are the ones most Tulsa homeowners land on. We bring the chart with the estimate so you can hold it against your siding.
Installed properly over sound decking, a metal roof should give a Tulsa home 40 to 60 years. Standing seam often goes longer because there are no exposed fasteners to work loose or leak.
Most Tulsa metal roof jobs land between about $12,000 and $30,000 in 2026, depending on square footage, pitch, panel type and how much tear off is involved. Standing seam runs higher than exposed fastener panels. We measure before we quote and the estimate is free.
Sometimes. If the decking is sound and there is only one layer of shingles, a Tulsa metal roof can go over the top on purlins. Two layers or rot underneath and we tear off first — and we say so before you sign.
What people said once the job was finished and the trucks were gone.
"Tore off two layers of old shingles and found rotten decking underneath. They showed me the boards, told me what the change would cost, and let me decide before going ahead."
"Green metal over the whole house and the carport. Looks sharp, and it is quiet inside when it rains, which honestly surprised me."
"The skylight had leaked for two years and three different people had caulked it. These folks reflashed it properly and that was the end of it."